Pontiac Fiero 1988 Service Manual page 915

7C-8
HYDRAULIC CLUTCH
1 - F L Y W H E E L
2 - DRIVE PLATE
ASM.
3 - PRESSURE
PLATE
4 - J-29074
520019-7C
Figure 11 Clutch Pressure Plate & Disc
•
Install or Connect
1. Lightly lubricate the clutch fork ends that con-
tact the bearing and completely pack full the
I.D. recess or the release bearing, with P/N
1051344 or equivalent.
2. Release bearing on the transaxle retainer with
both fork tangs fitted into bearing O.D. groove.
3. Transaxle assembly as outlined in Section 7B2
or 7B3 of this manual.
NOTICE:
Clutch lever must not be moved
toward flywheel until transaxle is bolted to the
engine or damage to the transaxle could occur.
FLYWHEEL
F+l
Remove or Disconnect
(Figure 11)
1. Transaxle assembly as outlined in Section 7B2
or 7B3.
2. Pressure plate and clutch disc assembly as previ-
ously outlined in this section.
L U B R I C A T E
H E R E
520020-7C
Figure 12 Release Bearing Lubrication
3. Flywheel attaching bolts and flywheel
assembly.
E3
Install or Connect
1. Flywheel and attaching bolts.
1 U Tighten
Torque bolts to 70 Nnn (50 lb. ft.).
Install or Connect
1. Pressure plate, clutch disc assembly and release
bearing as previously outlined in this section.
2. Transaxle assembly as outlined in Sections 7B2
or 7B3.
UNIT REPAIR
CLUTCH MASTER CYLINDER
r " j Remove or Disconnect
(Figure 13)
Master cylinder as outlined in On-vehicle
Service.
Unscrew filler cap and drain surplus fluid.
N E V E R R E - U S E F L U I D B L E D OR
DRAINED FROM A SYSTEM.
Pull back dust cover.
Circlip together with retaining washer and push
rod.
Shake cylinder to eject plunger assembly.
Lift leaf of spring retainer and remove spring
assembly from plunger.
Compress spring to free valve stem from key-
hole of spring retainer, thus releasing tension of
spring.
1.
3.
5.
6.