Pontiac Fiero 1988 Service Manual page 1350

REAR END 7J5
17 LOCK ASSEMBLY
18 BOLT — LOCK ATTACHING (2)
G 9 4 1 4 2
Fig. 8-Rear Compartment Lid Lock Assembly
19 LOCK CYLINDER
20 GASKET
21 RETAINER
22 SCREW (2)
GS4143
Fig. 9-Rear Compartment Lock Cylinder
i Raise or lower striker (15) as required
• Tighten bolts (16)
Lock assembly binding on side of striker
• Loosen bolts (16)
• Move striker (15) left or right as required
• Tighten bolts (16)
Leading edge too high or low (either side)
• Loosen nuts (5) (both hinges)
• Move both hinges left or right as required
• Tighten nuts (5)
19A. LOCK CYLINDER
20A. C O V E R
21A. RETAINER
22A. S C R E W S
23A. S U P P O R T
G94503-7J-P
Fig. 10 - Installing Lock Cylinder - 9 7 Style
Lid too far left or right
e Loosen nuts (5) (both hinges)
• Move both hinges left or right as required
• Tighten nuts (5)
Lid too far fore or aft (either side)
Loosen bolts (1)
Align lid
Tighten bolts (1)
Inspect
Lid for proper operation and alignment
•
•