Pontiac Fiero 1988 Service Manual page 1358

ROOF 8J-3
Tighten
Nuts (4) to 10 N-m (7 M b )
10. Two roof panel to cowl panel attaching screws (2)
11. Headlining assembly
12. Dome lamp assembly
13. Sunshade assemblies
14. Upper garnish moldings
15. Windshield assembly. Refer to Section 2J.
16. Shroud top vent screen. Refer to Section 4J.
17. Wiper arms. Refer to Section 8E in the chassis
portion of this manual.
18. First three fender-to-side rail attaching bolts from
windshield on right and left fenders.
19. Vista vent assembly (if equipped)
20. Roof drip moldings
FORMED HEADLINING
The one piece formed headlining consists of
molded substrate covered with a foam-backed cloth
facing which is common to all models. The one piece
construction allows the headlining assembly to be held
in place with two fasteners. Final attachment is
accomplished by the installation of related hardware
and interior moldings.
4 - +
1.
2.
3.
4.
5.
6.
7.
8.
9.
-•4-
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Remove or Disconnect (Figure 5)
Sunshade assembly
Coat hooks
Dome lamp assembly
Upper seat belt anchor assemblies
Rear quarter trim panels
Right and left side upper garnish moldings
Vista vent (if equipped)
Headlining assembly (13) - pull down on
headlining carefully to release fasteners.
Two headlining fasteners (14) from fastener
retainers (15)
Install or Connect (Figure 5)
Two fasteners (14) into fastener retainers (15)
Dome lamp wiring harness through dome lamp
opening
Headlining (13) to roof and secure fasteners
Rear quarter trim panels
Upper seat belt anchor assemblies
Tighten
Anchor bolts to 35 N-m (26 ft-lb)
Right and left side upper garnish moldings
Dome lamp connector to wiring harness
Dome lamp assembly
Coat hooks
Sunshade assembly
DOME LAMP ASSEMBLY
The dome lamp operates in conjunction with the
door jamb switches, instrument panel light switch or
the switches mounted on the dome fixture. The dome
13 FORMED HEADLINING
14 FASTENER
15 FASTENER RETAINER
G9411 5
Fig 5-lnstalhng Formed Headlining
lamp harness extends up the right windshield pillar and
across the roof inner panel to the dome lamp.
1.
2.
3
4.
Remove or Disconnect (Figure 6)
Lens assemblies
# Insert a flat-bladed tool between tab on lens
(17) and housing (16)
• Pry lens loose and remove
Bulbs
Four housing attaching screws (18)
Harness connector (19) from wiring harness (20)
Install or Connect (Figure 6)
As per illustration
SUNSHADE ASSEMBLY
The sunshade assemblies are attached to the roof
panel with three attaching screws (Fig. 7). To remove
or install the sunshades (21), remove or install the three
attaching screws (22).
INTERIOR UPPER GARNISH MOLDINGS
The upper garnish molding is constructed of
plastic and is painted to match the interior of the
vehicle. Plastic and metal clips retain the upper garnish
molding to the roof side rail and windshield pillar.
Remove or Disconnect (Figure 8)
1. Upper seat belt anchor assembly