Pontiac Fiero 1988 Service Manual page 1290

STATIONARY GLASS 2J-S
J900026-6-P
Fig. 7 - Removing Tape from Quarter W i n d o w
J90025-6-P
Fig. 8 - Location of Tape and Service Line on Quarter
W i n d o w
2. Reactivate tape residue on quarter window by
wiping with 3M General Purpose Cleaner No.
08984 or equivalent.
3. Apply a layer of 3M Scotch Mount Acrylic foam
Tape, part no. Y-4225 or equivalent over existing
tape residue rolling over tape to assure adhesion
before removing orange release liner.
4. Apply 60 lb test monofilament line to outer edge
of tape (see Fig. 8).
5. Quarter window to body opening, pressing firmly
to assure adhesion to body.
6. Back window to quarter filler panel.
7. Quarter vent grille
WINDSHIELD AND BACK GLASS
Short Installation Method
The short method is used on urethane
installations only. Any prior service installation using
butyl tape or other installations of unknown material
must be replaced using the extended method.
Prep and Sealing (Figure 9)
1. Clean around edge and inside surface of glass
with alcohol. Allow to air dry.
2. Apply clear primer to perimeter of glass edge and
7 mm (9/32") inboard on inner surface.
3. Apply black primer over clear primer on glass.
Allow five minutes to dry.
4. Apply smooth continuous bead of adhesive over
inside edge of glass where primed (Fig. 9). Tip
bead of adhesive slightly inboard.
Extended Installation Method
The extended method is necessary on butyl tape
or urethane installation if after removal of glass, the
urethane or butyl base is damaged or must be removed
for metal or paint repair.
Prep and Sealing (Figure 9)
1. Scrape or chisel old adhesive or butyl tape from
pinch-weld flanges. There should not be any
mounds or loose pieces left.
2. Apply black primer to any exposed surface on
pinch-weld flanges. Allow five minutes to dry.
3. Enlarge nozzle furnished in kit as shown in
Figure 9.