Pontiac Fiero 1988 Service Manual page 1261

9B-6 CRUISE CONTROL
CRUISE
C O N T R O L
CABLE
INSTALLATION AND
ADJUSTMENT PROCEDURE
1 — ACCELERATOR CABLE MUST BE INSTALLED
PRIOR
TO
CRUISE CONTROL
CABLE
INSTALLATION.
2 — WITH CRUISE CABLE ATTACHED AT ENGINE
BRACKET. INSERT CABLE SLUG IN CRUISE
PULLEY SLOT.
3 — INSERT CABLE IN SERVO BRACKET.
4 — PULL SERVO ASM. END OF CABLE TOWARD
SERVO WITHOUT MOVING IDLER PULLEY.
5 — IF ONE OF THE SIX HOLES IN THE SERVO
ASM. TAB LINES UP WITH CABLE PIN, PUSH
PIN THRU HOLE AND CONNECT PIN TO TAB
WITH RETAINER [9].
6 — IF A TAB HOLE DOES NOT LINE UP WITH
THE PIN, MOVE THE CABLE AWAY FROM
THE SERVO ASM. UNTIL THE NEXT CLOSEST
TAB HOLE LINES UP AND CONNECT PIN TO
TAB WITH RETAINER [ J ] .
CAUTION DO NOT STRETCH CABLE SO AS TO MAKE
A PARTICULAR TAB HOLE CONNECT TO PIN. THIS
COULD PREVENT ENGINE FROM RETURNING TO
IDLE.
1 — CRUISE SERVO
2 — CRUISE CABLE; MUST BE
INSTALLED IN DIRECTION SHOWN
3 — CRUISE PULLEY (BRACKET ASM.)
4 — IDLER PULLEY (BRACKET ASM.)
5 — TBI UNIT (ENGINE)
6 — BRACKET ASSEMBLY (ENGINE)
7 — TBI PULLEY (ENGINE)
8 — TAB (SERVO)
9 — RETAINER
10 — ACCELERATOR CABLE
11 — SLUG (CABLE ASM.)
12 — PULLEY SLOT
H 2 0 0 2 6 9 B
Fig. 802 Cruise Servo/Cable - L4