Pontiac Fiero 1988 Service Manual page 1313

SJ-2
DOORS
ARMREST PLUG
ARMREST SCREWS (3)
ARMREST
ARMREST HANGER PLATES
REMOTE MIRROR BEZEL
CABLE ATTACHING SCREW (1)
T R I M P A N E L
8 TRIM PANEL FASTENERS (9)
9 RIVETS (1/4" DIA. x
1/2" A L U M I N U M )
10
STIFFENER —
DOOR I N N E R P A N E L
G 9 4 0 9 8
Fig. 1-Door Trim Panel and Armrest
WINDOW REGULATOR HANDLE
Remove or Disconnect (Figures 2 and
3)
Tools Required:
. J-9886 Door Handle Clip and Trim Pad Remover
(or equivalent)
J-24595B Door Trim Pad and Garnish Molding
Clip Remover (or equivalent)
1. Clip (12)
• Depress trim panel.
m Insert J-9886 between handle and bearing
plate (13). Tool should be in same plane as
handle (Figure 2).
• Push tool as indicated in Figure 3.
2. Handle (11)
3 Plate (13)
Install or Connect (Figures 2 and 3)
L Plate (13)
2. Clip (12) on handle
3. Handle (11)
m Position handle at same angle as opposite
side handle.
• Press handle onto regulator spindle to
engage clip.
DOOR LOCK KNOB AND REMOTE HANDLE
BEZEL
Remove or Disconnect (Figure 4)
1. Covers (17)
2. Screws (16)
3. Lock knob (19)
• Use a small flat-bladed tool such as a
screwdriver.
• Insert blade between end of knob and rod
and pry to release knob.
• Slide knob forward to remove.
4. Remote handle bezel (15)
1.
2.
3.
4.
Install or Connect (Figure 4)
Remote handle bezel (15)
Lock knob (19)
• Insert lock rod through hole in bezel.
© Place end of knob on rod.
• Slide knob rearward until end of rod goes
into depression in end of knob.
m Force knob against bezel until rod snaps
into knob.
Screws (16)
Covers (17)
DOOR TRIM PANEL
Remove or Disconnect (Figure 1)
Tools Required: