125C-34 AUTOMATIC TRANSAXLE
•
Element (412)
® Element plate (411)
409
ROLL PIN
410
ROLL P I N , CAPPEtJ
H125-178*
Figure 82 Setting Center Roll Pin Height
411 PLATE, THERMOPLASTIC ELEMENT
412 THERMO-ELEMENT
413 WASHER, THERMO-ELEMENT
414 WASHER, THRUST- CASE COVER/DR. SPRKT.
H 1 2 5 - 1 1 9 *
Figure 83 Setting Element Height
17 CONNECTOR, COOLER FITTING
31 SEAL ASSEMBLY, A X L E OIL
H125C-85
Figure 84 Left Hand Axle Seal & Cooler Fittings
Assemble (Figure 82 and 83)
•
Set thermo pin height with J-29023
•
Install the element plate (411)
•
Install the element (412)
o Install the washers (413)-use J-29023 to set
the washer height.
Seal
•
1.
2.
3.
4.
5.
6.
Inspect (Figure 84)
Left hand axle seal (31) for damage
Replacement Procedure
0
Remove or Disconnect
• Seal (31)
j-»4-| Install or Connect
• Seal (31) use 3-26938 or J-29130
Assemble (Figure 81)
Case cover
Thrust washer (414) - use petrolatum to hold in
place.
Pin (422), chamfered end first
Piston (421)
Spring (419)
Gasket (415) - use petrolatum to hold in place.
[•»<-[ Install or Connect (Figures 81 and 85)
•
Gasket (416) to case cover
•
Case cover (401) to case
•
Coat (A) with thread sealer (Figure 84-A)
•
Remaining bolts and torque as shown in Figure
84A
•
Retainer (701) to manual valve (406)
Figure 84A Bolt Hole Locations
Input Shaft End Play
Measure (Figures 86 and 87)
Tools required:
J-26958-10 Adapter plug
J-26958 Loading tool and J-26958-11
bracket
J-28544 Input shaft lifter