Pontiac Fiero 1988 Service Manual page 807

125C-20 AUTOMATIC TRANSAXLE
2. Pawl (706)
3.
Shaft
(709)
4.
Retainer
(708)
5. C u p
Plug
with a
9 mm (3/8
w
) rod
138 PIPE, GOVERNOR OIL
1
PARTICLE BOARD
• H 1 2 5 - 5 3 0
Figure 4 7 G o v e r n o r Pipe Replacement
Inspect (Figure
47)
• Governor pipe (138) for damage or cracks
Governor Pipe Replacement Procedure
|^-»| Remove or Disconnect (Figure 47)
Tool Required:
J-28585 Snap Ring Remover
# Pipe (138) with J-28585, pry out.
Use particle board to protect case. Pipe is
sealed in place.
[ H M ^ J
Install or Connect
1. Coat both ends of the pipe (138) with Loctite
719 ® or equivalent.
2. Pipe (138) into case (112), tap gently with
a soft mallet.
3. Retainer (143) and bolt (142) torque to 24
N-m
(18 ft. lbs.)
r8l Inspect
• 3rd oil cup plug (127) for cracks or loose fit
Jrd Oil C u p Plug R e p l a c e m e n t Procedure
Remove or Disconnect (Figure 48)
• Cup Plug (2) - use #3 screw extractor with 13
mm (1/2") ground off.
j-H-j Install or Connect
Cup Plug (2) tap until seated in case - use a 6
mm (1/4") rod.
1
E X T R A C T O R , #3 MODIFIED
2
P L U G , CUP - D I R E C T C L U T C H
(3rd)iJ
H I 2 5 - 5 2 *
Figure 4 8 Cup Plug Removal
ffi
Inspect (Figure 4)
# Manual Shaft oil seal (113) for damage
M a n u a l S h a f t R e p l a c e m e n t Procedure
Remove or Disconnect
Seal (113) - pry out - check bore for burrs.
Smooth with fine stone if necessary.
Install or Connect
• Seal (113) lip side up use 13 mm or 9/16"
socket - tap with mallet until seated.