Pontiac Fiero 1988 Service Manual page 1342

REAR QUARTERS 6J-9
2. T c i i t
-riant
3.
4,
L
2.
3.
To avoid damage on plastic and fiberglass panels,
c*iefu!ly disengage or unseat the T clip (36) with
a thin-bladed tool.
Rivet (37) and molding clip (38)
Molding (39)
Install or Connect (Figure 11)
Molding clip (38) and rivet (37) to body
T clip (36) to molding (39)
Molding (39)
Two push-pull retainers (35)
2.
3.
4.
5.
6.
REAR FENDER PANEL ASSEMBLY
Remova or Disconnect (Figure 16)
L Rocker panel cover
2. Rear fender finish molding
3. Seven rivets (40)
4. Fender to wheelhouse panel screws (41)
5. Fender panel (42)
6. U nuts (43)
7. Seal strip (44) from fender panel
| ^ 4 J
Install
or Connect (Figure 16)
1. Apply adhesive to seal strip and fender mounting
surface (15) befoie installation.
Seal strip (44) to fender panel
U nuts (43) to fender panel (42)
Fender panel (42)
Fender to wheelhouse panel screws (41)
Seven rivets (40)
NOTICE: Care must be taken when fasteners are
installed to plastic or fiberglass components. To
prevent damage, align all parts before installation
of fasteners.
7. Rear fender finish molding
8. Rocker panel cover
REAR ROOF PANEL ASSEMBLY
It is not necessary to remove rear quarter
windows when removing rear roof panel assembly.
|<h^ Remove or Disconnect (Figure 17)
1. Rear compartment lid and weatherstrip (refer to
Section 7J)
2. Rear compartment side cover panels
3. Rear compartment cover extensions
4. Back window side filler panels
5. Four rear roof panel to upper frame side rail bolts
(46)
6. Tail lamp assemblies (refer to Section 7J)
7. Six rear roof panel to frame bolts (47)
8. Rear fender finish moldings
9. Loosen upper portion of fender from top
35 P U S H - P U L L R E T A I N E R (2)
36 T - C L I P
37 R I V E T
38 M O L D I N G C L I P
39 M O L D I N G
G 9 4 1 3 2
Fig. 15-Rear Fender Finish Molding