Pontiac Fiero 1988 Service Manual page 1309

4 J - 6 FRONT END
1. WEATHERSTRIP - F R O N T COMPARTMENT
2. BUTT J08NT '
G 9 4 4 9 3 - 4 J P
Fig. 5 - Installing Front Compartment Weatherstrip
1. C O V E R
2. S C R E W S
G 9 4 4 9 2 - 4 J P
Fig. 6-lnstalling Optional G l a s s Roof Vent Storage
Cover
Always use care when handling fenders to avoid
marring the surfaces.
1.
2.
3.
1.
Remove or Disconnect (Figure 7)
Side marker lamp assembly (34)
Rocker panel (front portion)
Bolts and rivets
• Top of fender to chassis (33)
• Inner wheelwell panel to fender (36)
• Upper forward front fender to fascia (32)
• Rivet (37)
Fender panel (30)
V I Important
Fender panel is held in place at rocker panel and
the inner wheelwell panel with a tab. Remove
carefully to avoid damage.
Install or Connect (Figure 7)
Fender panel (30)
• Rocker panel tab through outer fender
panel
m Tuck fender panel under fascia and inner
wheelwell tab
Bolts, attaching
• Upper forward front fender to fascia (32)
m Inner wheelwell panel to fender (36)
m Top at fender to chassis (33)
• Rivet front fender to fascia at marker light
(37)
3. Side marker lamp assembly (34)
4. Rocker panel
Inspect
For proper alignment of panel at hood, door,
wheelhousing and fascia. The clearance between fender
and door, and fender and front compartment hood
should be 4 mm (5/32").
FRONT WHEELHOUSE PANEL
J 4 " » |
Remove or Disconnect (Figure 8)
1. Attachments at
# Fender panel (36)
m Chassis (39)
m Fascia (40)
2. Wheelhousing panel
f S Important
+4°
1.
2.
Panel is retained to fender panel by a tab at center
of wheel opening.
Install or Connect (Figure 8)
Wheelhousing tab to fender
Attachments at
# Fascia (40)
# Chassis (39)
# Fender panel (36)
MOLDING
The moldings on the fascia and the front fender
where it attaches to the fascia are not removable. The
rear portion of the front fender has a molding that is
removable.
2.
3.
4"»| Remove or Disconnect (Figure 9)
1. Wheelhousing panel (rear half)
Two nuts (47)
Molding (46)
| + 4- |
Install or Connect (Figure 11)
Molding (46)
Two nuts (47)
Wheelhousing panel (rear half)
Inspect
For proper alignment
ROCKER PANEL COVER TO FRONT FENDER
EXTENSION
See Section 6J in the body portion of this manual
for removal and installation procedure.
1.
2.
3.