Pontiac Fiero 1988 Service Manual page 1334

REAR QUARTERS
6J-1
SECTION 6J
REAR QUARTERS
NOTICE; The anti-theft label found on some major body panels, engines, and transmissions must be masked
prior to painting, rustproofing, undercoating, etc. The mask m u s t be removed following the above operations.
Failure to keep the label clean and readable may result in liability for violation of Federal Vehicle Theft Prevention
Standard, and subject the vehicle owner to possible suspicion that the part was stolen.
NOTICE: Care must be taken when servicing any fiberglass (SCM) panel or component. Fasteners retaining
such panels or components must be hand started to prevent damage to fiberglass parts. Always use the specified
torque values given for SMC parts to assure safe and proper retention.
CONTENTS
Quarter Trim 6J-1
Rocker Panel Cover 6J-1
Rocker Panel Cover Extensions 6J-1
Rear Compartment Side Panel Cover 6 J-2
Rear Compartment Cover Extension,
37 Style 6J-2
Back Window Side Filler Panel, 37
Style 6J-2
Back Window to Quarter Filler
Panel, 97 Style 6J-2
Rear Quarter Trim Panel 6J-3
Speaker Assembly 6J-3
Speaker Grille 6J-4
Lower Pressure Relief Valve 6J-5
Applique Panel Assembly 6J-5
Upper Pressure Relief Valve 6J-6
Fuel Tank Filler Door 6J-7
Locking Fuel Filler Door and Pocket
Assembly 6J-7
Fuel Filler Door Remote Latch and
Cable Assembly 6J-7
Exterior Panels and Moldings 6J-7
Rear Wheelhouse Panel 6J-7
Rear Fender Finish Molding 6J-7
Rear Fender Panel Assembly 6J-9
Rear Roof Panel Assembly 6J-9
QUARTER TRIM
ROCKER PANEL COVER
|«"»| Remove or Disconnect (Figure 1)
1. Two wheelhousing screws (1)
2. Cover plates (2)
3. Three rivets (3) under cover plates (2)
4. Seven rivets (3) from rocker panel (4)
5. Rocker Panel (4)
r — — a
| + » | Install or Connect (Figure 1)
1. Rocker panel (4)
2. Seven rivets (3) to rocker panel (4)
3. Three rivets (3) under cover plates (2)
4. Cover plates (2)
5. Two wheelhousing screws (1)
ROCKER PANEL COVER TO DOOR PANEL
EXTENSION
[++| Remove or Disconnect (Fig. 2)
1. Rivets (1)
2. Extension by lifting up on extension (3) to
disengage upper flange from clips (2) on body.
Install or Connect
1 Extension to door panel by placing upper flange
over clips (2) and pushing down on extension.
2. Rivets (1)
ROCKER PANEL COVER TO FRONT FENDER
EXTENSION
4-4
1.
2.
3.
Remove or Disconnect (Fig. 2)
Rocker panel cover
Rivet (6)
Extension (7) by lifting up on extension to
disengage upper flange from clips (2).
p+j
Install or Connect
1. Extension (7) to front fender by placing upper
flange over clip (2) and pushing down on
extension
2. Rivet (6)
3. Rocker panel cover
ROCKER PANEL COVER TO QUARTER
EXTENSION
1.
Remove or Disconnect (Fig. 2)
Rocker panel cover
2. Rivets (4)
3. Extension (5) by lifting up on extension to
disengage upper flange from clips (2) on body