Pontiac Fiero 1988 Service Manual page 839

7B22 5-SPEED {ISUZU} 7§MM MANUAL TRANSAXLE
Cable Adjustment Procedure
Figure 4
1. Disconnect negative ( —) battery cable.
2. Place transaxle in first gear.
3. Loosen shift cable attaching nuts (E) at transaxle
levers (D) and (F) shown in Figure 4.
4. Remove console and trim plates as required for
access to shifter.
5. With shifter lever in first gear position (pulled to
left and held against stop), insert alignment pins
H and G as shown in view C.
6. Remove lash from transaxle by rotating lever
(D) in direction of arrow while tightening nut
(E) view A. Levers (D) and (F) should be kept
from moving during this process. Similarly,
tightening nut (E) on lever (F). (No biasing
required.) Again levers (D) and (F) must remain
stationary. Nut (E) on levers (D) and (F) tight-
ened to 27 Nnn (20 lb. ft.).
7. Ensure reverse inhibit cam is against roller and
align if necessary.
8. Remove alignment pins H and G at shifter
assembly.
9. Replace console trim plate.
10. Reconnect negative battery cable.
While cycling shifter from 1 to 2 and 2 to 1, the select
cable B should not move.
ON-VEHICLE SERVICE
TRANSMISSION SHIFT C A B L E S .
F"+l Remove or Disconnect
Figures 2 and 3
Negative ( - ) battery cable.
1.
2. Place shifter in first gear.
3. Shift knob.
4. Front trim plate, see Section 8C.
5. Shifter trim plate.
6. Rear console pad assembly.
7. E.C.M., see Section 6E2.
8. E.C.M. electrical connections.
9. Front carrier to I.P. reinforcement.
10. Carrier reinforcement, see Section 8C.
11. Carpet clips and rivets at console.
12. Heater control.
13. Radio, see Section 9A.
14. Carrier.
15. Shift cable and select cable from shifter.
16. Release rubber grommet on cable from body.
17. With transaxle in first gear, remove cables at
gear select lever assembly.
18. Mount attaching shift cable and select cable
assemblies to transaxle.
19. Shift and select cables from transaxle.
20. Pull cables through body into passenger
compartment.
F + ] Install or Connect
1. Pilot cable from passenger side through body
into engine compartment.
2. Cables to mounting bracket at transaxle.
3. Shift cables to transaxle.
4. With transmission lever assembly in first gear
position, cables to lever assembly.
5. Shift cables to shifter assembly.
6. Rubber grommet on cable to body.
7. Carrier assembly, console, see Section 8C.
8. Radio, see Section 9A„
9. Heater control, see Section 8C.
10. Carpet clips and rivets at console.
Figure 2 Shift & Select Cable Routing & Attachment at Transaxle