Pontiac Fiero 1988 Service Manual page 1336

REAR QUARTERS
6J-3
1.
R I V E T S -
ROCKER
E X T E N S I O N
TO DOOR
2. CLIPS
3. EXTENSION - ROCKER COVER PANEL TO DOOR
4. RIVETS - ROCKER EXTENSION TO QUARTER
5. EXTENSION - ROCKER COVER PANEL TO QUARTER
6. RIVET - EXTENSION TO FRONT FENDER
7. EXTENSION - ROCKER COVER PANEL TO FRONT FENDER
G 9 3 8 1 4
Fig.
2
- Rocker
Panel Cover Extensions
1.
2.
3.
4.
5.
Filler panel (11 A) by placing flat bladed tool
between body and filler panel at tape locations,
and prying filler panel loose from body
Install or Connect
Make sure spacers (10B) are in proper location
Filler panel (11 A)
Screws (10A)
Rear compartment side panel cover
Cloth tape from body
REAR
Q U A R T E R T R I M
PANEL
The rear quarter trim panel is a one-piece plastic
assembly. The panel fits into the seatback-to-motor
compartment panel.
Remove or Disconnect (Figure 7)
1. Upper shoulder belt anchor assembly
2. Screw (13)
3. Panel (14) Unseat retainer clip by grasping panel
with hands and pulling inward.
4. Seat belt webbing from slots (15) on panel (14)
Install or Connect (Figure 7)
1. Seat belt webbing through slots (15) on panel (14)
2. Panel (14). Apply pressure at retainer location
3. Screw (13)
4. Upper shoulder belt anchor assembly
| ^ | Tighten
Anchor bolt 35 to 48 N-m (26 to 35 ft-lb)
SPEAKER ASSEMBLY
1.
2.
3.
4.
1.
Remove or Disconnect (Fig. 8)
Rear quarter trim panel
Screws (13A)
Speaker assembly (14A)
Connector (15A) from connector (16A)
Install or Connect
Connector (15 A) to connector (16A)