Pontiac Fiero 1988 Service Manual page 851

7B2A-6 5-SPEED SSUZU MANUAL TRANSAXLE
14. Remove the
roll
pin,
and then remove
the pin
and reverse shift
lever.
15.
16.
17.
18.
19.
Remove input and output shafts with 3-4 shift
fork and shaft as an assembly.
Remove differential case assembly.
Remove the reverse shift bracket together with
four bolts,
and take out three
interlock pins
(Figure 15).
Remove the rear bearing outer races from the
transaxle case. Use J 24256-A with driver han-
dle J 8092 for the input shaft
race.
Use J 33370
with driver handle J 8092 for the output shaft
race (Figure 16).
Remove the outer races for the input shaft front
bearing, output shaft front and differential side
bearings. Use J 26941 with J 33367 for remov-
ing the input and output races in the housing and
the differential race in the case. Use J 26941
with a slide hammer to remove the differential
race in the housing (Figure. 17, 18 and 19).
G34014 7B2-AN
Figure 15 Reverse Shift Lever and Bracket
Figure 17 Input/Output Front Bearing Races
Figure 18 Differential Front Bearing Race
J33367
J26941-*.
1
hif
G34018 7B2-AN
Figure 16 Input/Cutput ?
B
sar Bearing Races
Figure 19 Differential Rear Bearing Race