Pontiac Fiero 1988 Service Manual page 1312

DOORS 5J-1
SECTION 5J
DOORS
NOTICE: The anti-theft label found on some major body panels, engines, and transmissions must be masked
prior to painting, rustprooing, undercoating, etc. The mask m u s t be removed following the above operations.
Failure to keep the label clean and readable may result In liability for violation of Federal Vehicle Theft Prevention
Standard, and subject the vehicle owner to possible suspicion that the part was stolen.
Doors 5J-1
Door Trim 5J-1
Armrest and Pull Handle Assemblies
5J-1
Window Regulator Handle 5J-2
Door Lock Knob and Remote
Handle Bezel 5J-2
Door Trim Panel 5J-2
Door Map Pocket 5J-4
Exterior Moldings 5J-4
Center Molding Assembly 5J-4
Rear Molding Assembly 5J-4
Door Assembly 5J-4
Door Sealing 5J-4
Inner Door Window Belt Sealing
Strip 5J-4
Outer Door Window Belt Sealing
Strip 5J-5
Inner Panel Water Deflector 5J-5
Door Opening Weatherstrips and
Channels 5J-5
Door Opening Weatherstrip 5J-6
Weatherstrip Channels 5J-7
Door Hardware Lubrication
5J-7
Hardware Attachment Thread
Locking 5J-7
Spring Clips 5J-7
Connecting Rods and Locking Rods
5J-7
Inside Remote Handle
5J-7
Outside Handle
5J-7
Outer Door Panel Assembly 5J-7
Door Lock Striker 5J--9
Door Jamb Switch 5J-11
Outside Mirrors 5J-11
Outside Mirror - Manual 5J-11
Mirror Glass - Manual 5J-12
Remote Control Mirror - Manual 5J-12
Remote Control Mirror Glass -
Manual 5J-12
Remote Control Mirror Glass -
Power 5J-12
Power Mirror Drive Unit 5J-13
Door Glass Assembly 5J-14
Door Glass Adjustment 5J-14
Window Regulator Cam Assembly ........... 5J-14
Regulator Assembly - Manual 5J-15
Regulator Assembly - Power 5J-15
Rear Cam 5J-17
Front Glass Run Channel/Support
Assembly 5J-17
Cam Assembly - Front Door Inner
Panel 5J-17
Door Lock Assembly 5J-17
Door Ajar Switch 5J-18
Lock Cylinder Assembly 5J-18
Power Door Lock Systems 5J-18
Power Lock Actuator 5J-18
Door Bell Crank 5J-19
Door Hinge System 5J-19
Door Removal/Installation
5J-20
Door Hinge
5J-20
DOORS
This section of the manual contains the service
operations necessary for the removal, installation,
adjustment and sealing of door assemblies and the
individual hardware and trim components. It is divided
into three subsections:
• Door Trim
- removal and installation
procedures for all door trim items.
• Exterior
Moldings - procedures for attaching
exterior door moldings.
• Door Assembly
- common items of door
assemblies including door and side roof rail
weatherstrip and all lock system components.
DOOR TRIM
ARMREST AND PULL HANDLE ASSEMBLIES
Remove or Disconnect (Figure 1)
1.
Armrest plug (1)
2. Screws (2)
3. Armrest (3)
Install or Connect (Figure 1)
1. Armrest (3)
2. Screws (2)
3. Armrest plug (1)