Shift Shaft Seal - Pontiac Fiero 1988 Service Manual

7B3-16
MUNCIE
282
(5-SPEED)
MANUAL TRANSAXLE
SHIFT SHAFT SEAL
1. 27 N-m (20 L B S . FT.)
2. LEVER
3. T R A N S A X L E
4. SHIFT SHAFT A N D SEAL
J10254-7B3-P
Figure 12 Shift Shaft Seal
NOTICE:
Prior to any vehicle service that
requires removal of the clutch lever assembly, the
master cylinder pushrod must be disconnected
from the clutch pedal. If not disconnected, per-
manent damage to the slave cylinder will occur if
the clutch pedal is depressed while the clutch
lever assembly is disconnected.
CLUTCH SHAFT AND/OR BUSHINGS
[ T l
J36037
f T I UPPER BUSHING
H 2 0 0 2 4 - 7 B 3
Figure 13 Upper Bushing Removal
Remove or Disconnect
1. Transaxle.
2. Clutch Release Lever.
3. Pry out seal.
4. Using J 36037 and a hammer, drive the upper
clutch shaft bushing into the housing.
5. Clutch shaft and bushing by sliding shaft out of
the case at a slight angle.
6. Lower clutch shaft bushing by using J 36032 in
bushing engaging the second step on remover
below the bushing. Tighten the screw to expand
legs.
[ T l J 3 6 0 3 2
H 2 0 0 2 5 - 7 B 3
Figure 14 Lower Bushing Removal
M
Install or Connect
1. Lower bushing using J 36033 with J 36190.
2. Clutch shaft.
fTI
L O W E R B U S H I N G
m
J36033
fT]
J36190
H 2 0 0 2 6 - 7 B 3
Figure 15 Lower Bushing Installation