4J-2 FRONT END
V I E W A
1. S H R O U D TOP V E N T
S C R E E N
2 . SCREWS
3.
D R I V E NAILS
4 . R I V E T
5.
6.
SPRING
F A S T E N E R S
G 9 4 4 9 1 - 4 J - P
Fig. 1-Shroud Vent Top Screen
2. Retainer (16)
Filler Assembly
Remove or Disconnect (Figure 2)
Bolts (10)
1 .
2.
3.
+4*
1.
2.
3.
Cover (13) and filler (14) assembly
Cover (13)
Install or Connect (Figure 2)
Cover (13)
Cover (13) and filler (14) assembly
Bolts (10)
Hinge Assembly
J4-+[ Remove or Disconnect (Figure 2)
Bolts (11)
Door assembly (8)
Bolts (10)
Hinge (9)
Install or Connect (Figure 2)
Hinge (9)
Bolts (10)
Door assembly (8)
Bolts (11)
Front and Rear Gap Adjustment
1. Loosen four bolts (10)
2. Align as necessary
3. Tighten four bolts (10)
Side-to-Side Gap Adjustment
1. Loosen two bolts (11)
2. Align as necessary
3. Tighten two bolts (11)
HOOD ASSEMBLY
The hood is composed of a single outer panel and
an inner reinforcement. Both panels are composed of
fiberglass.
1.
2.
3.
4.
1.
2.
3.
4
ft
Adjust (Figure 2)
Remove or Disconnect (Figure 3)
1. Bolts - two upper support attaching (19)
2. Nuts - hinge to body (23)
3. Hood (17)
Install or Connect (Figure 3)
Hood (17)
Nuts - hinge to body (23)
Bolts - two upper support attaching (19)
Inspect
For proper operation and alignment