Pontiac Fiero 1988 Service Manual page 1316

DOORS 5J-5
28
REAR MOLDING
REAR MOLDING SCREW
CENTER MOLDING
PLASTIC RETAINER
CLIP NUT
REAR CLIP
CENTER CLIPS
FRONT CLIP
FRONT CLIP SCREW
G94101
Fig. 5-Exterior Door Moldings
Outer Door Window Belt Sealing Strip
4 - +
4 - +
1.
2.
3.
4.
5.
6.
7.
B
1.
2.
3.
4.
5.
6.
7.
Remove or Disconnect (Figure 6)
Door trim panel
Water deflector (34)
Front filler sealing strip (32)
Mirror
Door glass
Sealing strip attaching screws
Sealing strip (29)
Install or Connect (Figure 6)
Sealing strip (29)
Screws
Door glass
Mirror
Front filler sealing strip (32)
Water deflector (34)
Door trim panel
1.
2.
3.
4.
Remove or Disconnect (Figures 1,7 and 8)
Door trim panel
Armrest hanger plates (4)
Stiffener (10)
Water deflector (34) - use a flat-bladed tool such
as a putty knife to release sealer. Keep blade
between inner panel and the string
embedded in the sealer.
that is
Inspect
1.
2.
3.
4.
For holes or tears in deflector. Apply waterproof
tape to both sides if necessary. Replace deflector
if it cannot be properly repaired.
Install or Connect (Figures 1,7 and 8)
Water deflector (34). Apply additional strip caulk
and tape as required.
Stiffener (10)
Armrest hanger plates (4)
Door trim panel
Inner Panel Water Deflector
The water deflector is secured by a string loaded
sealing material and by sealing tape. When removal of
deflector is required, it must be properly sealed for
replacement. If additional sealing material is required,
strip caulking is recommended.
For access to inner panel, the deflector may be
either partially or completely detached as required.
DOOR OPENING WEATHERSTRIPS AND
CHANNELS
The door opening weatherstrips are a bulbar type.
They are installed on the body pinch-weld flange
around the door opening and are friction retained on
pinch-weld around door opening and adhesive retained
in the channels around the window glass opening.
There are four screws at the beltline.