Pontiac Fiero 1988 Service Manual page 1372

SEATS 9J-9
channel when lock control
lever is activated.
2. Adjuster lock bar 2. Lubricate lock bar
sticking or binding.
pivot. If bar is binding,
eliminate cause of binding
or replace adjuster.
3. When left adjuster 1. Right adjuster either 1. Loosen adjuster to floor
locks, right adjuster rearward or forward of pan bolts or nuts. Move
is between lock posi- left adjuster. one adjuster forward or
tions.
rearward as far as possible
and the other adjuster the
opposite direction.
4. Seat hard to move 1. Adjusters new, not 1. Operate seat to full-
forward or rearward. broken in.
forward and full-rearward
positions several times to
work new tightness out of
channels.
2. Adjuster(s) improperly 2. Lubricate adjuster chan-
lubricated.
nels with Lubriplate Auto-
Lube A or equivalent.
3. Adjuster(s) binding 3. Replace adjuster.
due to bent or damaged
channels.
4. Adjusters not in par- 4. Loosen floor pan attach-
allel alignment with each ing bolts or nuts, align
other. adjusters parallel on floor
pan and retighten bolts or nuts.
A F 9 PNEUMATIC SEAT
SEATBACK ASSEMBLY, TRIM COVER AND
BLADDER BAG
1.
2.
3.
4.
7.
8.
Remove or Disconnect (Fig. 9)
Seat assembly from vehicle.
Recliner cover attaching screws and slide cover
(9) downward and rearward of the seat.
Unzip underside of backseat trim cover and
remove hog rings from bottom corners of
seatback cover.
Hog rings from trim curtain on underside of seat
cushion.
Work tube harness connector (3) out from under
inboard edge of foam on bottomside of seat
cushion and disconnect.
Raise corner of seatback trim over upper portion
of recliner. Mechanism to expose two
recliner-to-seatback bolts. Remove bolts.
Inner hinge arm attaching bolt (11, Fig. 5).
Lift seatback and work seatback bladder bag
tubes (4) out from under cushion.
10. Hog rings from side rods and support wires
securing trim cover to seatback frame.
11. Seatback trim cover
12. Hog rings securing upper and lower edges of
bladder bag (4) to seatback.
13. Carefully peel cemented area of bladder bag away
from foam. Avoiding tearing foam.
14. Bladder bag.
Install or Connect
Install reverse of removal procedure. During
installation of bladder bag a nitril, nonstaining spray
adhesive such as 3M Super Trim Adhesive 08090, or
equivalent may be used. Apply a coat of adhesive to
both the bladder bag and the area marked on the foam
where the bag is located.
FRONT SEAT CUSHION ASSEMBLY, TRIM
COVER, SWITCH AND TUBE HARNESS
9. Seatback assembly.
2.
3.
4.
Remove or Disconnect (Fig. 9)
Seat adjusters (Ref. Seat Adjuster Assembly
procedure).
Recliner cover (9).
Escutcheon (1) from switch.