Pontiac Fiero 1988 Service Manual page 1280

GENERAL INFORMATION 1J-7
6. SMC — SHEET MOLDED COMPOUND
7. RIM REACTION INJECTION MOLDED URETHANE
8. RRIM REINFORCED REACTION INJECTION MOLDED URETHANE
9 . TPO — THERMO PLASTIC OLEFIN
G93819
Fig. 11-Exterior Panel Identification
G 9 3 7 0 1 - 1 - B G
Fig. 1 2-Removing Paint Surrounding Damage
Fig. 13-Tapering Substrate Surrounding Damage
Fig. 14-Tape Support for Repair Material
until a uniform color and consistency is
achieved (Fig. 15).
Apply the mixed repair material with a
squeegee or plastic spreader. Apply a light
coat over the entire area; then continue
application to a level slightly above the
surrounding contour. Allow the mixture to
cure 20 to 30 minutes at 16°C to 2 7 ° C (60°F
to 80°F). If low areas or pits remain, mix
and spread additional adhesive or use 3M
Flexible Parts Putty #05903 or equivalent
(Fig. 16).