Pontiac Fiero 1988 Service Manual page 1297

3J-2 UNDERBODY
-M-
3. Rear console pad assembly. Refer to the
appropriate section in the chassis portion of this
manual.
4. Three screws (3).
5. Seatback-to-motor compartment panel (1).
Carefully pry fasteners (3) from retainers (4).
Install or Connect (Figure 1)
1. Seatback-to-motor compartment panel (1).
2. Three screws (3).
3. Rear console pad assembly. Refer to the
appropriate section in the chassis portion of this
manual.
4. Console shifter plate assembly. Refer to the
appropriate section in the chassis portion of this
manual.
5. Rear quarter trim panels. Refer to Section 6J.
LOWEFt GARNISH MOLDINGS
^4°
1.
2.
3.
Remove or Disconnect (Figure 2)
Five garnish molding plugs (7)
Five garnish molding screws (6)
Lower garnish molding (5). Pull upward and out
at rear of garnish molding (5) to disengage from
upper garnish molding (8).
1.
2.
3.
Install or Connect (Figure 2)
Lower garnish molding (5)
Five garnish molding screws (6)
Five garnish molding plugs (7)
FLOOR CARPETS
The floor carpet consists of molded right and left
side carpet assemblies. Floor pan insulators are
attached to the floor carpet assemblies. The right and
left side floor carpets may be serviced separately.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
Remove or Disconnect (Figures 1,2 and 3)
Seats(s), refer to Section 9J.
Seatback-to-motor compartment panel (1)
Front console pad. Refer to the appropriate
section in the chassis portion of this manual.
Lower garnish molding(s) (5).
Inboard seat belt(s). Refer to Section 9J.
Carpet(s) (9). Disengage carpet from retainers
(10) in console (11). There are six retainers per
side.
Install or Connect (Figures 1,2 and 3)
Carpet(s) (9)
Inboard seat belt(s). Refer to Section 9J.
Lower garnish molding(s) (5)
Front console pad. Refer to the appropriate
section in the chassis portion of this manual.
Seatback-to-motor compartment panel (1)
Seat(s), refer to Section 9J.