7J-2 REAR END
1 BOLTS — HINGE TO LID (4)
2 SCREW — TORQUE ROD (UNDER TENSION)
3 TORQUE ROD
4 HINGE
5 NUTS — HINGE TO BODY (2)
6 REAR COMPARTMENT LID
G838Q5
4 HINGE
5 NUT — HINGE TO BODY (2)
7 HOOK — TORQUE ROD RETAINING
Fig. 1-Rear C o m p a r t m e n t Lid A t t a c h m e n t
REAR COMPARTMENT TORQUE RODS
G94138
4 - +
Remove or Disconnect (Figures 3, and 6)
Fig. 2-Rear Compartment Lid Hinge
5. Carburetor air intake duct
6. Rear compartment side panels
7. Rear compartment lid
8. Partially lower lid and remove wood blocks
1. Hinge (4, Fig. 2)
2. Screw (13)
3. Pin (9) - with end of torque rod resting against
plywood, grasp U end of rod (8) and pull
rearward to release pin.
4. Rod (3) from hook (7)
5.
Rod (3)
pM^j Install or Connect (Figures 3 and 6)
Rod (3)
Rod (3) in hook (7)
Pin (9)
• With torque rod resting against plywood,
grasp U end of rod (8) and pull rearward to
insert pin.
•
Release U end (8) of rod and be sure that
end of rod hooks over pin.
Screw (13)
Hinge (4, Fig. 2)
1.
2.
3.
4.
5.
Inspect
For proper alignment of rear compartment lid.
ft
Adjust
To increase tension on torque rod, move the pin
(9) rearward one hole.