CRANKING SYSTEM 6D2-3
Fig. 3 Flywheel to Pinion Clearance
S E R V I C E PROCEDURES
CRANKING SYSTEM
Starting motors do not require lubrication except
during overhaul.
When the motor is disassembled for any reason,
lubricate as follows:
1— CONTACT DISC
2— PLUNGER
3— SOLENOID
4— RETURN SPRING
5— SHIFT LEVER
6— BUSHING
7— PINION STOP
8— CLUTCH
9— FIELD COIL
10— ARMATURE
11— BRUSH
12— TERMINALS
5MT and 10 Ml Starters
1. The roll type overrunning clutch requires no
lubrication; however, the drive assembly should
be wiped clean. Do Not clean in any degreasing
tank, or with grease dissolving solvents; this will
dissolve the lubricant in the clutch mechanism.
Use silicon grease General Electric CG321, Dow
Corning 33 Medium, or equivalent, on the shaft
underneath the overrunning clutch assembly.
2. Avoid excessive lubrication.
C D D O
r S
y\H
Fig. 4 Cross Section of 5MT Starting Motor