Pontiac Fiero 1988 Service Manual page 1207

81-8 LIGHTING SYSTEMS AND HORNS
1 — QUARTER PANEL
2 - LAMP ASSY.
3 - RIGHT REAR CAR
HARNESS
4 - BOLT
5 - FASCIA
6 - REFLECTOR ASSY.
7
- NUT
BULB & SOCKET
ASSY.
9 - BOLT
10 - LAMP ASSY •
& RIGHT
LEFT
11 - U-NUT
12 - BACKING PLATE
Fig. 8B-6 License Plate and Rear Sidemarker Lights
Fig. 8B-7 Rear T a i i / S t o p / T u r n Signal Lights
4. Two screws at light assembly
REAR COMPARTMENT LIGHT
Replacement Bulb: Trade
Candlepower
1. Raise rear compartment lid
Bulb from socket
No. 168, 3
2.
1.
Install or Connect
Bulb into socket
Lower rear compartment lid
REAR TAIL/STOP/TURN SIGNAL LIGHTS
Fig. 8B7
Replacement Bulb (All Except GT Models):
Trade No. 2057, 32/2 Candlepower
Replacement Bulbs (GT Models Only):
m Tail/Stoplights: Trade No. 2057, 32/2
Candlepower
+ Taillights Only: Trade No. 194, 2 Candlepower
m
Turn Signals Only: Trade No. 1156, 32
Candlepower
The taillight lens is two pieces. To remove a bulb,
remove the appropriate piece. Each piece is attached to
the body by three screws which are recessed under
rectangular black tabs.
Remove or Disconnect
1. Open rear compartment lid
1.
2.
3.
4.
5.
6.
Three black tabs covering screws by prying
carefully with a screwdriver
One screw under each tab
Tailight lens
Bulb socket from lens by pushing locking tabs
and turning to the left
Bulb from socket
Install or Connect
Bulb into socket
Socket into lens (be sure tabs lock)
Taillight lens
Three screws
Adjust
Lens position as needed before final tightening of
screws
Three black tabs
Close rear compartment lid
REMOTE DIMMER SWITCH
The remote dimmer switch assembly is on the
steering column support under the instrument panel.
1.
2.
3.
4.
Remove or Disconnect
Instrument panel steering column cover (see
Section 8C)
Electrical connection at dimmer assembly
Two screws at assembly
Dimmer assembly