Pontiac Fiero 1988 Service Manual page 856

5-SPEED
SSUZU MANUAL TRANSAXLE
7B2A-11
2. Install the front outer bearing races for the input
shaft, output shaft and differential into the
clutch housing. Apply oil to the bearing races
before installation. Using J 33371 with driver
handle J 8092, press input race into housing
(Figure 34). Using J 7817 with driver handle
J 8092, press output race into housing (Figure
35). Using J 8611-01 with driver handle J 8092,
press differential race into housing (Figure 36).
3. Apply grease to three interlock pins, and install
them on the clutch housing (Figure 37).
4. Install the reverse shift bracket on the clutch
housing. Use 3rd/4th shift shaft to align bracket
to housing. Install retaining bolts and tighten to
specification. Make sure shaft operates
smoothly after installation (Figure 38).
G34033-7B2-AN
Figure 34 Front Input Shaft Bearing Race
Figure 35 Front Output Shaft Bearing Race
J-8092
G34035-7B2-AN
Figure 36 Front Differential Bearing Race
1. P I N : I N T E R L O C K
2 . L O C K P I N : 5 T H
3. L O C K P I N : 3 R D - 4 T H
SHIFT SHAFT: REV.
G35632 7B2 AN
Figure 37 Interlock Pins
G34037-7B2 AN
Figure 38 Reverse Shift Bracket