Pontiac Fiero 1988 Service Manual page 1323

5J-12 DOORS
D O U B L E T E R M I N A L
S I N G L E T E R M I N A L
G91841-5B-BG
Fig. 18-Door J a m b Switches
2. Mirror attaching nuts (67)
3. Front filler weatherstrip
4. Door trim panel
Mirror Glass - Manual
1.
Remove or Disconnect (Figure 19)
Upper screw by putting mirror glass (63) in
full-down position for access
Lower screws by putting mirror glass (63) in
full-up position for
a c c e s s
Mirror glass assembly (63)
Install or Connect (Figure 19)
Mirror glass assembly (63)
Lower screws by putting mirror glass (63) in
full-up position for access
Upper screws by putting mirror glass (63) in
full-down position for access
Remote Control Mirror - Manual
-•4-
1.
2.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
Remove or Disconnect (Figure 20)
Door trim panel
Remote control cable end
Front filler weatherstrip
Mirror attaching nuts (67)
Mirror (68)
Install or Connect (Figure 20)
Feed cable through door opening
Mirror (68)
Mirror attaching nuts (67)
Front filler weatherstrip
Remote control cable end
Door trim panel
Remote Control Mirror Glass - Manual
Remove or Disconnect (Figure 20)
1. Mirror (68)
2. Upper screws by putting mirror glass (69) in
full-down position for access
3.
4.
+4°
1.
2.
3.
4.
63 MIRROR G L A S S A S S E M B L Y
64 MIRROR H O U S I N G
65 M O U N T I N G STUDS (2)
66 G A S K E T
67 NUTS (2)
G 9 4 1 1 1
Fig. 19-Outside Mirror - Manual
Lower screws by putting mirror glass (69) in
full-up position for access
Mirror glass assembly (69)
Install or Connect
Mirror glass assembly (69)
Lower screws by putting mirror glass (69) in
full-up position for access
Upper screws by putting mirror glass (69) in
full-down position for access
Mirror (68)
Remote Control Mirror Glass Assembly - Power
The glass assembly may be removed without
removing the mirror from the vehicle.
Remove or Disconnect (Figure 21)
Grasp inboard and outboard edges of glass (71)
with fingers
Pull rearward to disengage glass from pivot (74)
Install or Connect (Figure 21)
Align both worm gear shafts on glass with drive
drive gears (75)
Press in on glass (71) until it snaps into position
on pivot (74)
Inspect
For proper operation