Pontiac Fiero 1988 Service Manual page 1315

5J4 DOORS
V
Inspect
Trim panel retainers (8) for damage and proper
installation.
I-H-I Install or Connect
1.
2.
3.
4.
5.
6.
7.
1. Insert flange in hole
2. Rotate retainer to engage flange
Water deflector for proper installation
Install or Connect (Figure 1)
Remote control mirror cable end (if equipped)
• Cable
m Screw (6)
Wire harness (if equipped)
Panel (7)
• Insert top of panel in retainer
• Insert remote handle through panel
• Align retainers (8) with holes
• Tap into place with palm of hand or a clean
rubber mallet.
Bezel
Lock knob
Window regulator handle (if equipped)
Armrest (3)
Door Map Pocket
Remove or Disconnect
Tools Required:
J-23554 Inverted Nut Driver
Door trim panel
Six inverted nuts with J-23554
CAUTION: Wear eye protection to
prevent injury when cutting studs
To allow access for J-23554, cut approximately 6
mm (1/4") from map pocket studs with suitable
tool.
Door map pocket
3.
[Tl
Important
If the left side door map pocket is being replaced,
be sure to transfer the spring clip at the rear inner
seam to the new map pocket to prevent
interference with the emergency brake handle.
- • 4 - 1
Install or Connect
Door map pocket
Six inverted nuts with J-23554
Door trim panel
EXTERIOR MOLDINGS
1.
2.
3.
CENTER MOLDING ASSEMBLY
p-^
Remove or Disconnect (Figure 5)
1.. Door trim panel
2. Water deflector
3. Nut (24) from rear clip (25) - put window in
full-up position to allow access to nut from inside
of door panel.
4. Plastic retainer, (23) at outside door handle
5 Molding assembly (22)
Install or Connect (Figure 5)
1. Molding assembly (22)
2. Plastic retainer (23)
3. Nut (24)
4. Water deflector
' 5. Door panel
REAR MOLDING ASSEMBLY
Remove or Disconnect (Figure 5)
1. Door trim panel
2. Door outside handle
3. Nut (24) from rear clip (25)
4. Loosen rear section of outer door panel from top
to gain access to retaining screw
5. Screw (21)
6. Molding (20)
Install or Connect (Figure 5)
1. Molding (20)
2. Screw (21)
3. Rear section of outer door panel
4. Nut (24) to rear clip (25)
5. Outside door handle
6. Door trim panel
EXTENSION - ROCKER PANEL COVER TO
DOOR
See procedure in Section 6J in the body portion
of this manual.
- DOOR ASSEMBLY
DOOR SEALING
The following section contains service operations
necessary to remove and replace the components which
seal the door against air and water entry into the
passenger compartment.
loner Door Window Belt Sealing Strip
Remove or Disconnect (Figure 6)
1. Door trim panel
2. Retainer (31)
3. Sealing strip (30)
Install or Connect (Figure 6)
1. Sealing strip (30)
2. Retainer (31)
3. Door trim panel
+ 4 -