Manual Transaxle - Pontiac Fiero 1988 Service Manual

MUNCIE 282
(5-SPEED) MANUAL T R A N S A X L E 113-11
p + l
Install or Connect
1.
Bolt
23 Nnn (17
lb. ft.)
(13) through bracket
(12) to transaxle (14).
2. Select cable lever (11) on bracket (12).
3. Pin (9) through select cable lever (11) and
bracket (12) secured with retainer (10).
4. Collar (8) over manual shaft (5) with pin (7) to
select cable lever (11).
5. Shift cable lever (6) on manual shaft (5) with
washer (4) and nut (3) 83 N°m (61 lb. ft.).
|T] important
Do not allow manual shaft (5) to move while
torquing nut (3). Internal damage can occur.
6. Bracket (2) with bolt (1) 25 N-m (18 lb. ft.) to
transaxle (14).
7. Retainer to select cable.
8. Bolt 25 Nnn (18 lb. ft.) and retainer securing
shift cable to transaxle (14).
9. Select
and
shift cable
nuts
27 Nnn (20 lb.
ft.).
MANUAL TRANSAXLE
Remove or
Disconnect
1. Drain plug and drain transaxle.
2. Select and shift cables nuts securing cables to
transaxle brackets.
3. Back-up light switch wire and switch.
4. Shift cables and nut on stud securing bracket to
transaxle.
5. Two bolts securing select cable mount.
6. Two bolts attaching clutch slave cylinder
bracket.
7. Exhaust crossover pipe, see Section 6A2.
8. Nut, clip and wire from center stud.
9. Three upper bolts and one stud attaching trans-
axle to engine.
10. Install J 28467-A, J 35563, engine support fix-
tures. Attach fixture hook to engine lift ring and
raise engine enough to take the pressure off the
mounts (Figure 7).
11. Front and rear transaxle mounts.
1 - SHIFT CABLE
2 - NUT
3 - WASHER
4 - CABLE S T U D
5 - R E T A I N E R
6 - S E L E C T C A B L E
7 - L E V E R A S S E M B L Y
8 - L E V E R
9 - WASHER
1 0 - N U T
1 1 - C A B L E S T U D
1 2 - B R A C K E T A S S E M B L Y
1 3 - R E T A I N E R
1 4 - B O L T
M20003-7B3
Figure 6 Shift a n d Select Cable Routing a n d A t t a c h m e n t at Transaxle