Shift And Select Cables - Pontiac Fiero 1988 Service Manual

7B3-10 MUNCIE 282 (5-SPEED) MANUAL TRANSAXLE
11
12
13
14
15
16
17
18
Front carrier to I.P. reinforcement.
E.C.M. electrical connection, see Section 6E2.
E.C.M.
Rear console pad assembly, see Section 8C.
Shifter trimplate.
Front trimplate.
Shift knob and screw.
Negative battery cable.
S H I F T E R A S S E M B L Y
Remove or Disconnect
1. Steps 1 thru 14 as outlined in shaft cable and
select cable removal procedure.
2. Mark location of shifter assembly for
installation.
3. Shifter assembly nuts.
4. Shifter assembly from studs.
E
Install or Connect
1. Shifter assembly on four studs with nuts 24 N
#
m
(17
lb.
ft.).
2. Shift and select cables on shifter assembly with
retainers.
3. Steps 6-16 as outlined in shift and select cables
in installation procedures.
S H I F T A N D S E L E C T C A B L E S
F * * |
Remove or Disconnect
1. Retainers from cable ends securing cables to
shifter assembly.
2. Bolt and retainer fastening shift cable at
transaxle.
. . 3. Retainer from select cable.
4. Shift and select cables nuts from cable ball studs
at transaxle brackets.
5. Remove rubber grommet on cables from body.
Install or Connect
Cables from passenger side through body into
engine compartment.
2. Rubber grommet on cables to body.
3. Shift and select cable nuts 25 Nnn (18 lb. ft.) on
cable studs through transaxle brackets.
Retainer on select cable.
Bolt 25 N«m (18 lb. ft.) and retainer fastening
shift cable to transaxle.
Secure shift and select cables on shifter assem-
bly with retainers.
TRANSAXLE SHIFT L E V E R S AND
BRACKETS
Figure
3
E3
10
11
Remove or Disconnect
Select and shift cable nuts from cable studs.
Retainer from select cable.
Bolt and retainer from shift cable.
Bolt (1) and bracket (2) from select cable.
Nut (3) and washer (4) from manual shaft (5).
Shift cable lever (6) from manual shaft (5).
Pin (7) from collar (8) and select cable lever
(11).
Collar (8) from manual shaft (5).
Pin (9) and retainer (10) from select cable lever
(11).
Select cable lever (11).
Bolt (13) from bracket (12) and transaxle (14).
1 - TRANSAXLE
2 - FLUID LEVEL INDICATOR
J 1 0 0 0 5 7B3 A
Figure 5 Transaxle Dipstick