Radius-Server Auth-Port; Radius-Server Host; Radius Client - Motorola EX-3524 Cli Reference Manual

Example
radius-server
This command sets the RADIUS server network port. Use the no form to restore the
auth-port default.
Syntax
Default Setting
1812
Command Mode
Global Configuration
Example

radius-server host

This command specifies primary and backup RADIUS servers, and authentication
and accounting parameters that apply to each server. Use the no form to remove a
specified server, or to restore the default values.
Syntax
Console(config)#radius-server acct-port 181
Console(config)#
radius-server auth-port port-number
no radius-server auth-port
port-number - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
Console(config)#radius-server auth-port 181
Console(config)#
[no] radius-server index host host-ip-address [acct-port acct-port]
[auth-port auth-port] [key key] [retransmit retransmit] [timeout timeout]
index - Allows you to specify up to five servers. These servers are queried in
sequence until a server responds or the retransmit period expires.
host-ip-address - IP address of server.
acct-port - RADIUS server UDP port used for accounting messages.
(Range: 1-65535)
auth-port - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
key - Encryption key used to authenticate logon access for client. Enclose
any string containing blank spaces in double quotes.
(Maximum length: 48 characters)
– 171 –
Chapter 7
| Authentication Commands

RADIUS Client