Motorola EX-3524 Cli Reference Manual page 144

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

Chapter 5
| SNMP Commands
SNMP Target Host Commands
To send an inform to a SNMPv2c host, complete these steps:
1.
Enable the SNMP agent
2.
Create a view with the required notification messages
3.
Create a group that includes the required notify view
4.
Allow the switch to send SNMP traps; i.e., notifications
5.
Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.
To send an inform to a SNMPv3 host, complete these steps:
1.
Enable the SNMP agent
2.
Create a remote SNMPv3 user to use in the message exchange process
(page
147).
3.
Create a view with the required notification messages
4.
Create a group that includes the required notify view
5.
Allow the switch to send SNMP traps; i.e., notifications
6.
Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.
The switch can send SNMP Version 1, 2c or 3 notifications to a host IP address,
depending on the SNMP version that the management station supports. If the
snmp-server host command does not specify the SNMP version, the default is
to send SNMP version 1 notifications.
If you specify an SNMP Version 3 host, then the community string is interpreted
as an SNMP user name. The user name must first be defined with the
server user
command. Otherwise, an SNMPv3 group will be automatically
created by the snmp-server host command using the name of the specified
community string, and default settings for the read, write, and notify view.
Example
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands
snmp-server enable traps (141)
(page
138).
(page
138).
– 144 –
(page
148).
(page
146).
(page
141).
(page
148).
(page
146).
(page
141).
snmp-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents