Auto-Traffic-Control Alarm-Fire-Threshold - Motorola EX-3524 Cli Reference Manual

auto-traffic-control
alarm-fire-threshold
Default Setting
128 kilo-packets per second
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆
Once the traffic rate falls beneath the lower threshold, a trap message may be
sent if configured by the
clear command or snmp-server enable port-traps atc multicast-alarm-clear
command.
◆
If rate limiting has been configured as a control response, it will be
discontinued after the traffic rate has fallen beneath the lower threshold, and
the release timer has expired. Note that if a port has been shut down by a
control response, it will not be re-enabled by automatic traffic control. It can
only be manually re-enabled using the
command.
Example
This example sets the clear threshold for automatic storm control for broadcast
traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast alarm-clear-threshold 155
Console(config-if)#
This command sets the upper threshold for ingress traffic beyond which a storm
control response is triggered after the apply timer expires. Use the no form to
restore the default setting.
Syntax
auto-traffic-control {broadcast | multicast} alarm-fire-threshold threshold
no auto-traffic-control {broadcast | multicast} alarm-fire-threshold
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
threshold - The upper threshold for ingress traffic beyond which a storm
control response is triggered after the apply timer expires. (Range: 1-255
kilo-packets per second)
Default Setting
128 kilo-packets per second
Command Mode
Interface Configuration (Ethernet)
Chapter 14
snmp-server enable port-traps atc broadcast-alarm-
auto-traffic-control control-release
– 353 –
| Congestion Control Commands
Automatic Traffic Control Commands