Show Dot1Q-Tunnel; Configuring Protocol-Based Vlans; Table 89: Protocol-Based Vlan Commands - Motorola EX-3524 Cli Reference Manual

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

show dot1q-tunnel

Configuring Protocol-based VLANs

This command displays information about QinQ tunnel ports.
Command Mode
Privileged Exec
Example
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel mode access
Console(config-if)#interface ethernet 1/2
Console(config-if)#switchport dot1q-tunnel mode uplink
Console(config-if)#end
Console#show dot1q-tunnel
Current double-tagged status of the system is Enabled
The dot1q-tunnel mode of the set interface 1/1 is Access mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/2 is Uplink mode, TPID is 0x8100.
The dot1q-tunnel mode of the set interface 1/3 is Normal mode, TPID is 0x8100.
. .
.
Related Commands
switchport dot1q-tunnel mode
The network devices required to support multiple protocols cannot be easily
grouped into a common VLAN. This may require non-standard devices to pass
traffic between different VLANs in order to encompass all the devices participating
in a specific protocol. This kind of configuration deprives users of the basic benefits
of VLANs, including security and easy accessibility.
To avoid these problems, you can configure this switch with protocol-based VLANs
that divide the physical network into logical VLAN groups for each required
protocol. When a frame is received at a port, its VLAN membership can then be
determined based on the protocol type in use by the inbound packets.
.

Table 89: Protocol-based VLAN Commands

Command
protocol-vlan
protocol-group
protocol-vlan
protocol-group
show protocol-vlan
protocol-group
show interfaces
protocol-vlan
protocol-group
(412)
Function
Create a protocol group, specifying the supported
protocols
Maps a protocol group to a VLAN
Shows the configuration of protocol groups
Shows the interfaces mapped to a protocol group and the
corresponding VLAN
– 413 –
Chapter 17
| VLAN Commands
Configuring Protocol-based VLANs
Mode
GC
IC
PE
PE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents