Show Mvr - Motorola EX-3524 Cli Reference Manual

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

Chapter 20
| Multicast Filtering Commands
Multicast VLAN Registration

show mvr

Command Usage
Multicast groups can be statically assigned to a receiver port using this
command.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for multicast
streams. MVR group addresses cannot fall within the reserved IP multicast
address range of 224.0.0.x.
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If
MVR must be configured for an IGMP version 1 host, the multicast groups must
be statically assigned using the mvr vlan group command.
Example
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/7
Console(config-if)#mvr type receiver
Console(config-if)#mvr vlan 3 group 225.0.0.5
Console(config-if)#
This command shows information about the global MVR configuration settings
when entered without any keywords, the interfaces attached to the MVR VLAN
using the interface keyword, or the multicast groups assigned to the MVR VLAN
using the members keyword.
Syntax
show mvr [interface [interface] | members [ip-address]]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-12)
ip-address - IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
Default Setting
Displays global configuration settings for MVR when no keywords are used.
Command Mode
Privileged Exec
Command Usage
Enter this command without any keywords to display the global settings for MVR.
Use the interface keyword to display information about interfaces attached to the
– 490 –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents