Dot1X Pae Supplicant - Motorola EX-3524 Cli Reference Manual

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

Chapter 7
| Authentication Commands
802.1X Port Authentication

dot1x pae supplicant

Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-start 10
Console(config-if)#
This command enables dot1x supplicant mode on a port. Use the no form to
disable dot1x supplicant mode on a port.
Syntax
[no] dot1x pae supplicant
Default
Disabled
Command Mode
Interface Configuration
Command Usage
When devices attached to a port must submit requests to another
authenticator on the network, configure the identity profile parameters (see
dot1x identity profile
supplicant, and enable dot1x supplicant mode for those ports which must
authenticate clients through a remote authenticator using this command. In
this mode the port will not respond to dot1x messages meant for an
authenticator.
This switch can be configured to serve as the authenticator on selected ports
by setting the control mode to "auto" (see the
page
205), and as a supplicant on other ports by the setting the control mode
to "force-authorized" and enabling dot1x supplicant mode with this command.
A port cannot be configured as a dot1x supplicant if it is a member of a trunk or
LACP is enabled on the port.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#dot1x pae supplicant
Console(config-if)#
command on
page
209) which identify this switch as a
– 210 –
dot1x port-control
command on

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents