Radius-Server - Motorola RFS7000 Series Reference Manual

5-40 Overview

5.1.24 radius-server

Global Configuration Commands
Use this CLI command to enter the RADIUS Server mode. The system prompt changes from the default config
mode to RADIUS server mode.
NOTE
radius-server local
details see
Syntax
radius-server(host|key|local|retransmit|timeout)
radius-server host (A.B.C.D)
radius-server key(0|2| LINE)
radius-server local
radius-server retransmit <0-100>
radius-server timeout<1-1000>
Parameters
host
key
local
retransmit <0-100>
timeout <1-1000>
Usage Guidelines
RADIUS server host is used to configure RADIUS server details. These details are required for management
user authentication if AAA authentication has been defined as RADIUS.
Example
RFS7000(config)#radius-server local
RFS7000(config-radsrv)#
mode leads you to the radius-server context. For more
RADIUS Server Instance on page 13-1
Specifies a RADIUS server.
• A.B.C.D – IP address of RADIUS server.
Encryption key shared with RADIUS servers.
• 0 – Password specified as UNENCRYPTED.
• 2 – Password is encrypted with password-encryption secret.
• LINE – Text of shared key (up to 127 characters in length).
Configures local RADIUS server parameters. This takes you to a new
context. Refer to
radius-server
Specifies the number of retries to the active server.
• <0-100> – Number of retries for a transaction (default is 3).
Time to wait for a RADIUS server reply.
• <1-1000> – Wait time (default 5 seconds).
RADIUS Server Instance for more details.
config-