Dynamic Configuration - Motorola EX-3524 Cli Reference Manual

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

Chapter 1
| Initial Switch Configuration
Configuring the Switch for Remote Management
Link-Local Address:
FE80::260:3EFF:FE11:6700/64
Global Unicast Address(es):
2001:DB8:2222:7272::/64, subnet is 2001:DB8:2222:7272::/64
Joined Group Address(es):
FF02::1:FF00:0
FF02::1:FF11:6700
FF02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3
ND retransmit interval is 1000 milliseconds
ND reachable time is 30000 milliseconds
Console#show ipv6 default-gateway
ipv6 default gateway:
Console#

Dynamic Configuration

Obtaining an IPv4 Address
If you select the "bootp" or "dhcp" option, the system will immediately start
broadcasting service requests. IP will be enabled but will not function until a
BOOTP or DHCP reply has been received. Requests are broadcast every few minutes
using exponential backoff until IP configuration information is obtained from a
BOOTP or DHCP server. BOOTP and DHCP values can include the IP address, subnet
mask, and default gateway. If the DHCP/BOOTP server is slow to respond, you may
need to use the "ip dhcp restart client" command to re-start broadcasting service
requests.
Note that the "ip dhcp restart client" command can also be used to start
broadcasting service requests for all VLANs configured to obtain address
assignments through BOOTP or DHCP. It may be necessary to use this command
when DHCP is configured on a VLAN, and the member ports which were previously
shut down are now enabled.
If the "bootp" or "dhcp" option is saved to the startup-config file (step 6), then the
switch will start broadcasting service requests as soon as it is powered on.
To automatically configure the switch by communicating with BOOTP or DHCP
address allocation servers on the network, complete the following steps:
1.
From the Global Configuration mode prompt, type "interface vlan 1" to access
the interface-configuration mode. Press <Enter>.
2.
At the interface-configuration mode prompt, use one of the following
commands:
To obtain IP settings via DHCP, type "ip address dhcp" and press <Enter>.
To obtain IP settings via BOOTP, type "ip address bootp" and press <Enter>.
3.
Type "end" to return to the Privileged Exec mode. Press <Enter>.
2001:DB8:2222:7272::254
– 42 –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents