MVR is disabled.
No MVR group address is defined.
MVR VLAN ID is 1.
Use the mvr group command to statically configure all multicast group
addresses that will join the MVR VLAN. Any multicast data associated with an
MVR group is sent from all source ports, to all receiver ports that have
registered to receive data from that multicast group.
The IP address range from 126.96.36.199 to 188.8.131.52 is used for multicast
streams. MVR group addresses cannot fall within the reserved IP multicast
address range of 224.0.0.x.
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If
MVR must be configured for an IGMP version 1 host, the multicast groups must
be statically assigned using the
IGMP snooping and MVR share a maximum number of 255 groups. Any
multicast streams received in excess of this limitation will be flooded to all ports
in the associated VLAN.
MVR source ports can be configured as members of the MVR VLAN using the
switchport allowed vlan
MVR receiver ports should not be configured as members of this VLAN.
The following example enables MVR globally, and configures a range of MVR group
Console(config)#mvr group 184.108.40.206 10
This command causes the switch to immediately remove an interface from a
multicast stream as soon as it receives a leave message for that group. Use the no
form to restore the default settings.
[no] mvr immediate
mvr vlan group
switchport native vlan
– 487 –
| Multicast Filtering Commands
Multicast VLAN Registration