Dhcp Commands; Dhcp Client; Table 115: Dhcp Commands; Table 116: Dhcp Client Commands - Motorola EX-3524 Cli Reference Manual

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

24

DHCP Client

DHCP Commands

These commands are used to configure Dynamic Host Configuration Protocol
(DHCP) client functions.

Table 115: DHCP Commands

Command Group
DHCP Client
Use the commands in this section to allow the switch's VLAN interfaces to
dynamically acquire IP address information.

Table 116: DHCP Client Commands

Command
DHCP for IPv4
ip dhcp client class-id
ip dhcp restart client
show ip dhcp client-identifier
DHCP for IPv6
ipv6 dhcp client rapid-commit
vlan
ipv6 dhcp restart client vlan
show ipv6 dhcp duid
show ipv6 dhcp vlan
*
This command is only supported by the EX-3548.
Function
Allows interfaces to dynamically acquire IP address information
Function
Specifies the DHCP client identifier for an interface
Submits a BOOTP or DHCP client request
Shows the DHCP client identifier for all interfaces
*
Specifies the Rapid Commit option for DHCPv6 message
exchange
Submits a DHCPv6 client request
Shows the DHCP Unique Identifier for this switch
Shows DHCPv6 information for specified interface
– 531 –
Mode
IC
PE
PE
GC
PE
PE
PE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents