| System Management Commands
logging sendmail level
You can specify up to three SMTP servers for event handing. However, you must
enter a separate command to specify each server.
To send email alerts, the switch first opens a connection, sends all the email
alerts waiting in the queue one by one, and finally closes the connection.
To open a connection, the switch first selects the server that successfully sent
mail during the last connection, or the first server configured by this command.
If it fails to send mail, the switch selects the next server in the list and tries to
send mail again. If it still fails, the system will repeat the process at a periodic
interval. (A trap will be triggered if the switch cannot successfully open a
Console(config)#logging sendmail host 192.168.1.19
This command sets the severity threshold used to trigger alert messages. Use the
no form to restore the default setting.
logging sendmail level level
no logging sendmail level
level - One of the system message levels
the selected level down to level 0. (Range: 0-7; Default: 7)
The specified level indicates an event threshold. All events at this level or higher will
be sent to the configured email recipients. (For example, using Level 7 will report all
events from level 7 to level 0.)
– 118 –
111). Messages sent include