| LLDP Commands
lldp med-tlv ext-poe
Interface Configuration (Ethernet, Port Channel)
This option sends out SNMP trap notifications to designated target stations at
the interval specified by the
notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), the LLDP-MED MIB (ANSI/TIA 1057), or organization-specific LLDP-
EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
SNMP trap destinations are defined using the
Information about additional changes in LLDP neighbors that occur between
SNMP notifications is not transmitted. Only state changes that exist at the time
of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime to
detect any lldpRemTablesChange notification-events missed due to throttling
or transmission loss.
Console(config)#interface ethernet 1/1
This command configures an LLDP-MED-enabled port to advertise and accept
Extended Power-over-Ethernet configuration and usage information. Use the no
form to disable this feature.
[no] lldp med-tlv ext-poe
Interface Configuration (Ethernet)
This option advertises extended Power-over-Ethernet capability details, such as
power availability from the switch, and power state of the switch, including
whether the switch is operating from primary or backup power (the Endpoint
Device could use this information to decide to enter power conservation mode).
Note that this device does not support PoE capabilities.
– 508 –