| LLDP Commands
When LLDP is re-initialized on a port, all information in the remote systems LLDP
MIB associated with this port is deleted.
Console(config)#lldp reinit-delay 10
This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the no form
to restore the default setting.
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
The transmit delay is used to prevent a series of successive LLDP transmissions
during a short period of rapid changes in local LLDP MIB objects, and to
increase the probability that multiple, rather than single changes, are reported
in each transmission.
This attribute must comply with the following rule:
(4 * tx-delay) ≤ refresh-interval
Console(config)#lldp tx-delay 10
– 498 –