Chapter 21
| LLDP Commands
show lldp config
This command shows LLDP configuration settings for all ports.
Syntax
show lldp config [detail interface]
detail - Shows configuration summary.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
The following example shows all basic LLDP parameters are enabled on Port 1.
Console#show lldp config
LLDP Global Configuration
LLDP Enabled
LLDP Transmit Interval
LLDP Hold Time Multiplier
LLDP Delay Interval
LLDP Re-initialization Delay : 2 sec.
LLDP Notification Interval
LLDP MED Fast Start Count
LLDP Port Configuration
Port
Admin Status Notification Enabled
-------- ------------ --------------------
Eth 1/1
Tx-Rx
Eth 1/2
Tx-Rx
Eth 1/3
Tx-Rx
Eth 1/4
Tx-Rx
Eth 1/5
Tx-Rx
.
.
.
Console#show lldp config detail ethernet 1/1
LLDP Port Configuration Detail
Port : Eth 1/1
Admin Status : Tx-Rx
Notification Enabled : True
Basic TLVs Advertised:
port-description
system-name
system-description
system-capabilities
management-ip-address
802.1 specific TLVs Advertised:
*port-vid
*vlan-name
: Yes
: 30 sec.
: 4
: 2 sec.
: 5 sec.
: 4
True
True
True
True
True
– 512 –