Dot1X Timeout Quiet-Period; Dot1X Timeout Re-Authperiod - Motorola EX-3524 Cli Reference Manual

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

Chapter 7
| Authentication Commands
802.1X Port Authentication
dot1x timeout
quiet-period
dot1x timeout
re-authperiod
connected the network and the process is handled transparently by the dot1x
client software. Only if re-authentication fails is the port blocked.
The connected client is re-authenticated after the interval specified by the

dot1x timeout re-authperiod

Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
Related Commands
dot1x timeout re-authperiod (206)
This command sets the time that a switch port waits after the maximum request
count (see
page
203) has been exceeded before attempting to acquire a new client.
Use the no form to reset the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
This command sets the time period after which a connected client must be re-
authenticated. Use the no form of this command to reset the default.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
command. The default is 3600 seconds.
– 206 –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents