Clear Counters - Motorola EX-3524 Cli Reference Manual

Layer 2 gigabit ethernet poe/poe+ switch
Hide thumbs Also See for EX-3524:
Table of Contents

Advertisement

When auto-negotiation is disabled, the default speed-duplex setting is 100full
for 1000BASE-T ports.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The 1000BASE-T standard does not support forced mode. Auto-negotiation
should always be used to establish a connection over any 1000BASE-T port or
trunk. If not used, the success of the link process cannot be guaranteed when
connecting to other types of switches. However, this switch does provide a
means of safely forcing a link to operate at 1000 Mbps, full-duplex using the
giga-phy-mode
To force operation to the speed and duplex mode specified in a speed-duplex
command, use the
the selected interface.
When using the
settings will be determined by the
duplex mode under auto-negotiation, the required mode must be specified in
the capabilities list for an interface.
Example
The following example configures port 5 to 100 Mbps, half-duplex operation.
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Related Commands
negotiation (299)
capabilities (295)

clear counters

This command clears statistics on an interface.
Syntax
clear counters interface
command.
no negotiation
negotiation
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-12)
– 301 –
Chapter 10
command to disable auto-negotiation on
command to enable auto-negotiation, the optimal
capabilities
command. To set the speed/
| Interface Commands
Interface Configuration

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex-3548

Table of Contents