| General Commands
This command returns to Normal Exec mode from privileged mode. In normal
access mode, you can only display basic information on the switch's configuration
or Ethernet statistics. To gain access to all commands, you must use the privileged
"Understanding Command Modes" on page
The ">" character is appended to the end of the prompt to indicate that the system
is in normal access mode.
This command restarts the system.
When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory by the copy
running-config startup-config command.
This command resets the entire system.
This example shows how to reset the switch:
System will be restarted, continue <y/n>? y
– 78 –