| System Management Commands
Firmware can be uploaded and downloaded to or from an FTP/TFTP server. By
saving runtime code to a file on an FTP/TFTP server, that file can later be
downloaded to the switch to restore operation. The switch can also be set to use
new firmware without overwriting the previous version.
When downloading runtime code, the destination file name can be specified to
replace the current image, or the file can be first downloaded using a different
name from the current runtime code file, and then the new file set as the startup
Saving or Restoring Configuration Settings
Configuration settings can be uploaded and downloaded to and from an FTP/TFTP
server. The configuration file can be later downloaded to restore switch settings.
The configuration file can be downloaded under a new file name and then set as
the startup file, or the current startup configuration file can be specified as the
destination file to directly replace it. Note that the file "Factory_Default_Config.cfg"
can be copied to the FTP/TFTP server, but cannot be used as the destination on the
Table 14: Flash/File Commands
Automatic Code Upgrade Commands
upgrade opcode auto
upgrade opcode path
Specifies the file or image used to start up the system
Copies a code image or a switch configuration to or from
flash memory or an FTP/TFTP server
Deletes a file or code image
Displays a list of files in flash memory
Displays the files booted
Automatically upgrades the current image when a new
version is detected on the indicated server
Specifies an FTP/TFTP server and directory in which the
new opcode is stored
Shows the opcode upgrade configuration settings.
– 90 –