Connecting The Power Supply; Connecting The Power Supply - Digital Projection M-Vision 930 3D Series Installation And Quick Start Manual

Digital Projection M-Vision 930 Series

Connecting The Power Supply

1. Make sure the voltage switch is
set to the correct voltage.
2. Make sure the mains power
button is in the OFF position.
3. Lift the cable lock up, push the
mains connector in firmly and push
the lock down to secure the cable.
4. Switch the mains power button
ON.
Installation and Quick-Start Guide

CONNECTING THE POWER SUPPLY

1 2 3
Voltage switch
1
Mains power button
2
AC mains inlet with cable lock
3
Notes
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Rev C February 2015
page 4