Digital Projection M-Vision 930 Series
3D connections
3D sources up to 60Hz requiring frame doubling and left/right interleaving
1.
Connect to either of the following inputs on the connection panel:
•
HDMI 1
•
HDMI 2
•
HDBaseT
2.
Set
3D Format
in the
3D
menu to match the format of the incoming signal. Choose from
Top and Bottom
.
The
format is automatically detected by the projector.
Frame Packing
Frame sequential 3D sources up to 120Hz
•
Connect to the DVI input.
The Frame Sequential format is automatically detected by the projector and is supported on the DVI input only.
Dual Pipe 3D
1.
Connect the left eye output to the
HDMI 1
2.
Set
in the
menu to
3D Format
3D
Dual-Pipe
Connection Guide
socket and the right eye output to the
HDMI 2
.
1
2
3
4
1
HDBaseT
2
DVI
HDMI 1 / Dual Pipe LEFT
3
HDMI 2 / Dual Pipe RIGHT
4
SIGNAL INPUTS
Auto
,
Side by Side (Half)
and
socket.
Notes
For a complete listing of all
supported signal input modes, see
Appendix C: Supported Signal
Input Modes
in the Reference
Guide.
For a complete listing of pin
configurations for all signal and
control connectors, see
Appendix
E: Wiring Details
in the Reference
Guide.
Rev C February 2015
page 28