Table of Contents
Advertisement
Digital Projection M-Vision 930 Series
Image menu continued from previous page
Position and Phase
Press
ENTER/SELECT
to open the submenu.
•
V Position
and
H Position
Set the sliders as required.
•
Phase
Adjusts the phase of the pixel sampling clock relative to the incoming
signal. Adjust the phase if noise is visible.
•
Tracking
Adjusts the frequency of the pixel sampling clock. Flicker or vertical
banding indicate poor tracking.
•
Sync Level
Adjusts the voltage level of the signal detection circuitry. Adjust if the
projector loses sync during scenes where the signal drops below black.
Highlight the setting you wish to edit, and then press
or
arrow button to open the slider.
LEFT
RIGHT
Use the
LEFT
and
RIGHT
arrow buttons to adjust the slider.
Press
MENU
to close the slider.
Resync
Press
ENTER/SELECT
to force the projector to resynchronize with the current
input.
Operating Guide
USING THE PROJECTOR
Image >> Position and Phase
V Position
H Position
Phase
Tracking
Sync Level
Select Item
, or the
ENTER/SELECT
Image >>
Brightness
Contrast
Gamma
Adaptive Contrast
Saturation
Hue
Sharpness
Noise Reduction
Position and Phase
Resync
Select Item
100
100
– – – –
– – – –
– – – –
Adjust
[Menu] Return
100
100
2.2
Off
100
100
0
0
< Execute >
Adjust
[Menu] Return
Notes
Rev C February 2015
page 42
Advertisement
Table of Contents
